2008年11月7日星期五

Digital micromirror device

DLP chip
A Digital Micromirror Device, or DMD is an optical semiconductor that is the core of DLP projection technology, and was invented by Dr. Larry Hornbeck and Dr. William E. "Ed" Nelson of Texas Instruments (TI) in 1987.

The DMD project began as the Deformable Mirror Device in 1977, using micromechanical, analog light modulators. The first analog DMD product was the TI DMD2000 airline ticket printer that used a DMD instead of a laser scanner.

A DMD chip has on its surface several hundred thousand microscopic mirrors arranged in a rectangular array which correspond to the pixels in the image to be displayed. The mirrors can be individually rotated ±10-12°, to an on or off state. In the on state, light from the projector bulb is reflected into the lens making the pixel appear bright on the screen. In the off state, the light is directed elsewhere (usually onto a heatsink), making the pixel appear dark.

To produce greyscales, the mirror is toggled on and off very quickly, and the ratio of on time to off time determines the shade produced (binary pulse-width modulation). Contemporary DMD chips can produce up to 1024 shades of gray. See DLP for discussion of how color images are produced in DMD-based systems.

The mirrors themselves are made out of aluminium and are around 16 micrometres across. Each one is mounted on a yoke which in turn is connected to two support posts by compliant torsion hinges. In this type of hinge, the axle is fixed at both ends and literally twists in the middle. Because of the small scale, hinge fatigue is not a problem and tests have shown that even 1 trillion (1012) operations do not cause noticeable damage. Tests have also shown that the hinges cannot be damaged by normal shock and vibration, since it is absorbed by the DMD superstructure.

Two pairs of electrodes control the position of the mirror by electrostatic attraction. Each pair has one electrode on each side of the hinge, with one of the pairs positioned to act on the yoke and the other acting directly on the mirror. The majority of the time, equal bias charges are applied to both sides simultaneously. Instead of flipping to a central position as one might expect, this actually holds the mirror in its current position. This is because attraction force on the side the mirror is already tilted towards is greater, since that side is closer to the electrodes.

To move the mirrors, the required state is first loaded into an SRAM cell located beneath each pixel, which is also connected to the electrodes. Once all the SRAM cells have been loaded, the bias voltage is removed, allowing the charges from the SRAM cell to prevail, moving the mirror. When the bias is restored, the mirror is once again held in position, and the next required movement can be loaded into the memory cell.

The bias system is used because it reduces the voltage levels required to address the pixels such that they can be driven directly from the SRAM cell, and also because the bias voltage can be removed at the same time for the whole chip, so every mirror moves at the same instant. The advantages of the latter are more accurate timing and a more filmic moving image.

NOTE:

five regular modules


combination air processor


crucial pc4200 memory


emachine t2885 motherboard


clivia miniata reg


ecs nforce motherboards


e machine motherboards


electric coil inserter


emachines t2042 motherboard


encapsulated power modules


finest music components


cuw am motherboard


i gb ram


custom machined components


clamping device components


fn 1dlt delta


dell 4600 motherboard


fic au31 motherboard


ibm thinkpad motherboards


hydrant system components


hdd and memory


emachines t6528 motherboard


sdram - memory


emachines t3256 motherboard


dvd writer scsi


high density ddr


ddr 3 memory


dell e520 memory


clutch for hyundai


cisco interface modules

没有评论: